Very dense, water resistant and shrink-free, two-component filler based on epoxy resin. 
Can be applied up to 1.5cm. 
Apply on wood, steel, aluminum and polyester, above and below the waterline. In general, this epoxy filler is used in a two component paint system, but it is also more and more used in a single-component system, in combination with Epifanes Multi Marine Primer. Repair Reviews with Epifanes Epoxy Filler 1500 can be treated directly with a single-component primer or topcoat. On large surfaces, first apply a layer of poly-urethane topcoat and then finish with a one component paint Epifanes.
Sand after 24 hours at 18 ° C.
Dying time is 30-60 minutes dep. of the amount produced
Advice:
Clean surfaces well with degreaser to remove the greasy surface layer. This prevents flooding of the abrasive and is necessary in order to obtain a good adhesion of the paint on the filler. Afterwards sand with 100-120 Grit
Recoat:
After 24 hours at 18 ° C.
Mixing ratio in volume:
100: 50
Mix ratio by weight:
100: 50
Colours:
Grey